The officially official Devuan Forum!

onedevone

Member

Registered: Yesterday

Posts: 3  

Fail With DOT

For years I have been managing Artix, but I had never had a success on Devuan 5. Nor do I know how to set up network on Devuan.

What is happening:

1. I put DOT capable IPs in KDEs network manager GUI. Testing shows, that not DOT is used. Plain queries ((. It should be default, but isn't. It's been buffling me for years that you don't do this by default. This bears the question if you use your own creationa at all. If you were then you wouldn't allow plain text DNS querries, would you? I don't understand this behavior of nm.

2. I looked for "stubby-openrc" but cannot find it. I also theoreticaly could "cap_net_bind blah blah" reprogramm it (systemd has stubby working out of the box!). But I'm stuck and I don't want to dwell on it.

HOW do you (step by step) do stubby on open-rc Devuan 6? THIS IS A COMPLETE SHOWSTOPPER FOR ME. I cannot continue the setup until I have this issue resolved.

DOT via stubby works like charm on Artix runit.

How do you do this on Devuan 6 Opne-RC? Your help is going to be immensly appreciated.

Thanks.

ralph.ronnquist

Administrator

From: Battery Point, Tasmania, AUS

Registered: 2016-11-30

Posts: 1,561  

Re: Fail With DOT

What is DOT ?