The officially official Devuan Forum!

You are not logged in.

#1 2022-11-06 23:04:34

Mike-thinky
Member
Registered: 2021-10-28
Posts: 37  

Recovery after a badly failed update

Hi,

I have a laptop with 2 drives in it, a 250Gb nVME and a 1TSSD, anyway I did something (unknown) silly and it will not boot at all,

It did have Beowulf,as that was current at installation. I have separated out the files so that the ssd was for data storedaway from the home directory. I want to save as much as possible from /Home/Me as possible, but fully expect to do a fresh install of Chimera.
Can I trust the inbuilt install guide not to wipe the ssd when I want the os on the nvme.

I know I will have to use a live installation to copy out from /home/me.

Any other suggestions?

Offline

#2 2022-11-07 01:45:18

GlennW
Member
Registered: 2019-07-18
Posts: 300  

Re: Recovery after a badly failed update

Hi, in my experiences because it is a separate device it won't get hosed (deleted or formatted) unless you command it.

I think even a "set partitions automatically for..." depends on the device /dev/sda, /dev/sdb ,

I sometimes put an empty filename as a signal for similar devices. (edit hosed)

Last edited by GlennW (2022-11-07 01:49:26)

Offline

#3 2022-11-07 09:15:56

Camtaf
Member
Registered: 2019-11-19
Posts: 245  

Re: Recovery after a badly failed update

If your SSD is on a separate mount point to that which the installer uses, it won't be touched.
(You just have to create the mount point again.)

(It is always best to have a separate backup anyway, in case of corruption, whatever O/S you use).

Last edited by Camtaf (2022-11-07 09:16:45)

Offline

#4 2022-11-07 17:20:29

chris2be8
Member
Registered: 2018-08-11
Posts: 168  

Re: Recovery after a badly failed update

The first thing I'd try is to boot a live DVD/USB, mount the SSD and scp everything I want to save to another system (plugging in an ethernet cable if necessary). Then mount the nVME drive and save anything I wanted or what might show what went wrong.

Then I would check the data looks OK on the destination system. After that I'd be happy to start trying to repair the broken system.

Last edited by chris2be8 (2022-11-07 17:21:03)

Offline

#5 2022-11-07 20:15:19

aluma
Member
Registered: 2022-10-26
Posts: 43  

Re: Recovery after a badly failed update

Not quite a traditional option.
I would create another 15...20 GB partition on the nVME disk and install Chimera there.
After installation, you can move the /home directory Chimera to an SSD drive, fix the installed Beowulf, etc.

Offline

Board footer