The officially official Devuan Forum!

You are not logged in.

#1 2019-10-06 14:09:02

reverber
Member
Registered: 2019-10-06
Posts: 3  

Odroid HC1 / HC2: Headless Install

First of all, thanks to everyone who got Devuan rolling and keeps it going.

I am trying to get Devuan installed on an Odroid HC2 using the devuan_ascii_2.0.0_armhf_odroidxu4 image. It *seems* to work - mostly. I see that it pulls a DHCP address from the server, and I can ping it successfully.

However, I am unable to ssh to it. Ssh just times out at first, and then after about five minutes, I start getting "no route to host." Ping also dies at this point.

Nmap (while the network interface is up) shows that ssh is filtered.

Complicating things is that this is a headless box, so I cannot see what is going on. Anybody have any suggestions on troubleshooting while I impatiently wait for my UART kit to arrive?

Thanks for your help.

Offline

#2 2019-10-06 15:46:55

alphalpha
Member
From: Germany
Registered: 2018-01-23
Posts: 137  

Re: Odroid HC1 / HC2: Headless Install

maybe you can mount the micro sd on your main computer and modify the /etc/network/interfaces to a static ip and check the ssh server config

Last edited by alphalpha (2019-10-06 15:51:05)

Offline

#3 2019-10-07 12:19:50

reverber
Member
Registered: 2019-10-06
Posts: 3  

Re: Odroid HC1 / HC2: Headless Install

Thank you.
Everything looks fine as far as I can tell. I used to have Open Media Vault on it, so I know it isn't a hardware failure. OMV seemed like a bit of overkill for a backup solution, so I am going to go lean and use rsnapshot.

I was hoping maybe somebody else had paved the way for me smile.

Offline

Board footer