Dev1 Galaxy Forum / Which Excalibur install problems fixed by 6.1.1?

Re: Which Excalibur install problems fixed by 6.1.1?

dummy@example.com (rolfie) — Tue, 07 Jul 2026 15:27:00 +0000

- The installer did not activate the link for the Ethernet interface, so mirror, clock, etc. did not work while installing.

I would claim this is not an installer issue. If the network does not work its most likely an issue related to user input.

Re: Which Excalibur install problems fixed by 6.1.1?

dummy@example.com (stargate-sg1-cheyenne-mtn) — Tue, 07 Jul 2026 14:20:02 +0000

may or may-not help but still good information on raid at:

https://dev1galaxy.org/viewtopic.php?id=7213

and also perhaps:

https://dev1galaxy.org/viewtopic.php?id=7015

Re: Which Excalibur install problems fixed by 6.1.1?

dummy@example.com (rmrichesjr) — Sun, 05 Jul 2026 04:17:15 +0000

Thanks for the link. It doesn't look like the larger issues I encountered are covered, but then the installer problem I encountered with 6.0.0 and fixed in 6.1.0 doesn't appear to match the descriptions there.

Re: Which Excalibur install problems fixed by 6.1.1?

dummy@example.com (rbit) — Sun, 05 Jul 2026 04:04:57 +0000

For the installer ISOs, 6.1.0 -> 6.1.1 changes are listed here: https://git.devuan.org/devuan/installer … a1ca9fb841
Perhaps someone else with a raid setup can assist you with /dev/md124 problem.
I hadn't tested a 2-optical drive system with the installer in the 2nd drive, and was unaware of the issue.

Which Excalibur install problems fixed by 6.1.1?

dummy@example.com (rmrichesjr) — Sat, 04 Jul 2026 18:21:32 +0000

After doing a test VM from 6.1.0 starting a couple of months ago using the 'server' ISO, I tried to install Excalibur on the main physical machine and hit a few problems:

- The installer did not activate the link for the Ethernet interface, so mirror, clock, etc. did not work while installing.

- Installation of GRUB failed. Daedalus had a similar problem, but using chroot to create a grub config file and manually copying that config file into the Chimera installation's /boot/grub worked. For Excalibur, even with "mount --bind ..." for /dev, /proc, and /sys, grub-mkconfig still shows 3 errors "md124 not found" (where /dev/md124 is intended to be Excalibur's /boot partition).

- There's also a less significant issue for physical machines with two optical drives that if the CD is in the second drive, the beginning of the 'install base system' step errors out with "Failed to determine the codename for the release."

Is it documented which (if any) of the above is fixed between 6.1.0 and 6.1.1?

Meanwhile, I'll try to re-install from the 6.1.1 server ISO and then use chroot from the 6.1.1 Live CD if GRUB installation still fails.