The officially official Devuan Forum!

You are not logged in.

#1 2018-05-10 18:36:58

ubik
Member
Registered: 2018-05-10
Posts: 1

Odroid XU4 with ASCII RC - USB/net problem

I'm having a problem getting Devuan ASCII running on an Odroid XU4 (http://www.hardkernel.com/main/products … 3452239825), I'm not sure if I've missed something obvious or if there's a problem with the image - I've tried the ASCII beta and the RC.

I've copied the image to an SD card and it boots but the network interface doesn't come up.

As far as I can tell something is getting confused with the USB and making the network interface appear on the wrong bus / wrong speed interface:

root@devuan:~# lsusb -t
/:  Bus 06.Port 1: Dev 1, Class=root_hub, Driver=xhci-hcd/1p, 5000M
/:  Bus 05.Port 1: Dev 1, Class=root_hub, Driver=xhci-hcd/1p, 480M
    |__ Port 1: Dev 2, If 0, Class=Vendor Specific Class, Driver=r8152, 480M
/:  Bus 04.Port 1: Dev 1, Class=root_hub, Driver=xhci-hcd/1p, 5000M
    |__ Port 1: Dev 2, If 0, Class=Hub, Driver=hub/2p, 5000M
/:  Bus 03.Port 1: Dev 1, Class=root_hub, Driver=xhci-hcd/1p, 480M
/:  Bus 02.Port 1: Dev 1, Class=root_hub, Driver=exynos-ohci/3p, 12M
/:  Bus 01.Port 1: Dev 1, Class=root_hub, Driver=exynos-ehci/3p, 480M

If I boot a Debian image and do the same thing the network works and the interface appears under the high speed Bus 06 entry rather than the 480M Bus 05 entry.

When running the Devuan ASCII image I tried plugging in other USB devices to see if I can get something to work, the USB2 interface responds with a "New USB device found" message on the console, the upper USB3 port doesn't show any sign of recognising that something has been connected and the lower USB3 port gave an error when I plugged in a disk:

[  141.349656] usb usb3-port1: Cannot enable. Maybe the USB cable is bad?
[  142.319857] usb usb3-port1: Cannot enable. Maybe the USB cable is bad?
[  143.279971] usb usb3-port1: Cannot enable. Maybe the USB cable is bad?
[  144.241201] usb usb3-port1: Cannot enable. Maybe the USB cable is bad?
[  144.248239] usb 3-1: USB disconnect, device number 2
[  148.321980] usb usb3-port1: connect-debounce failed

The gigabit network interface is the third USB3 device.

I'm connecting to the XU4 with a serial adapter connected to the UART.

Is it something I've done or is it a bug?

If there's any other info that would help let me know.

Thanks.

Offline

Board footer