apt install --reinstall pulseaudio pavucontrol
Then open pavucontrol check if sound is muted usually it is and check witch card is on the output and what on input ,
Good luck
p.s Mind you i was on live usb stick when i was trying this.
Ive seen live cause issues before on distros. especial systemd and pulseaudio.
you can mess with "alsamixer" -c0 and all your pulseaudio settings / alsa settings.
good luck.
]]>EDIT: but yeah, I tried etertics once, its not nearly as good as I would have hoped...
Unless they improved since... last time I checked, somethings weren't changed that should have been...
]]>I use an xlr mic and external usb soundcard
I missed this bit. A USB card won't show up in lspci, use lsusb instead.
You can open a terminal and run this command:
udevadm monitor
Then plug the USB card in and see what the kernel & udev do with the device.
Which kernel versions are Mint & Void using? The stock kernel in Devuan beowulf might be too old to support the devices.
]]>dice wrote:lspci -knn | grep "Audio"
The grep needs to be expanded to show the kernel driver:
lspci -knn | grep -A2 "Audio"
@OP: have you read the beowulf release notes? If you have multiple sound cards then PulseAudio might need to be autostarted.
Use pgrep pulse to check if it's running and use aplay -l to list all available audio devices.
lspci -knn | grep -A2 "Audio"
00:1b.0 Audio device [0403]: Intel Corporation NM10/ICH7 Family High Definition Audio Controller [8086:27d8] (rev 01)
Subsystem: Lenovo NM10/ICH7 Family High Definition Audio Controller [17aa:304f]
Kernel driver in use: snd_hda_intel
Kernel modules: snd_hda_intel
aplay -l
**** List of PLAYBACK Hardware Devices ****
card 0: Intel [HDA Intel], device 0: ALC662 rev1 Analog [ALC662 rev1 Analog]
Subdevices: 1/1
Subdevice #0: subdevice #0
pgrep pulse says 3096
]]>lspci -knn | grep "Audio"
The grep needs to be expanded to show the kernel driver:
lspci -knn | grep -A2 "Audio"
@OP: have you read the beowulf release notes? If you have multiple sound cards then PulseAudio might need to be autostarted.
Use pgrep pulse to check if it's running and use aplay -l to list all available audio devices.
]]>lspci -knn | grep "Audio"
also try contacting etertics.
]]>p.s Mind you i was on live usb stick when i was trying this.
]]>