thanks!
]]>just for clarification: i did't nothing at MXLinux that line was added in Devuan.
Good. Just so you know what that line does...
/dev/sda3 / auto defaults,noatime 1 1
That says to mount sda3 (your MXLinux partition) at the root of the filesystem. Which means you would be running mx, not devuan.
Whereas, this line:
/dev/sda3 /mnt auto defaults,noatime 1 1
mounts the mx partition at /mnt, where it is available, but is not the system that's running at that time.
Changing '/dev/whatever' to 'UUID=' or 'LABEL=' is just a different way of identifying the partition. Sometimes it's necessary to do that. (e.g. multiple disks in the computer)
]]>just for clarification: i did't nothing at MXLinux that line was added in Devuan.
Of course. Sorry I didn't make that clearer.
]]>Question:
and if from mxlinux i go to fstab and change what is over there:
# Pluggable devices are handled by uDev, they are not in fstab /dev/sda3 / auto defaults,noatime 1 1
to this:
UUID=6e55911a-2620-4ab6-b2b5-1458602e6252 / ext4 defaults,noatime 0 1 UUID=0b4a75ba-8b74-47b1-8aaa-2d971f92732f swap swap defaults 0 0 LABEL=MXLinux /mnt auto defaults,noatime 0 0
Congratulations!!!! Didn't I suggest exactly that here?
]]>/dev/sda3 / auto defaults,noatime 1 1
for /dev/sda3: LABEL="MXLinux" UUID="66f3f330-78b2-4767-bc3e-8a9e7750e476" TYPE="ext4" PARTUUID="000f1103-03"
and this time it works!!
Thanks!!
]]>Any way,
Thank you very much for your help!!
]]>I'm back again, no it didn't blow up but nothing happened ...
Sad but it wasn't a big chance. Might try
yes
instead of auth_self if you aren't bored with it yet but i don't have all that much hope.
*About my previous commentary ... this time i got to read the whole line at the screen when restarted the system:
couldn't mount ext3 due to future incompatibilities
This is very likely unrelated. As shown by the blkid you posted on the last page your MXLinux partition uses ext4.
]]>*About my previous commentary ... this time i got to read the whole line at the screen when restarted the system:
couldn't mount ext3 due to future incompatibilities
]]><allow_any>auth_self</allow_any>
<allow_inactive>auth_self</allow_inactive>
<allow_active>auth_self</allow_active>
auth_self
(according to docs that should ask for authenticaten - root password?) or
yes
(which should just do it without further questions).
I am really stabbing in the dark here but i guess it's worth a try.
]]><message xml:lang="uk">Щоб змонтувати файлову систему, слід пройти розпізна$
<message xml:lang="zh_CN">挂载文件系统需要身份验证</message>
<message xml:lang="zh_TW">要掛載檔案系統需要先核對身分</message>
<defaults>
<allow_any>auth_admin</allow_any>
<allow_inactive>auth_admin</allow_inactive>
<allow_active>auth_admin_keep</allow_active>
</defaults>
</action>
Are you asking to change 'allow' for 'auth_self'?
]]>